Disassembling part 3

Today we did take some more parts out of the car.

We first started with clearing everything out of the trunk, including the gastank.

 We then dismounted the roof top.

 The sound amplifier was next to come out.

 The wires that were mounted on the floor and which went to the Nitrous oxide installation and stereo were disconnected.

 In this picture you see that the wires are rolled up tagged and put in a plastic to protect the wires and dashboard.

 This is the car as it is standing there now. Without the doors. We took them out

 Next we made several measurements.

 This is the plan I drew with all the measurements.
With this we will be able to control the movement of the car while welding in the new parts.

 This are some brackets made from 6 mm thick plate . These will be used as connector plates for the enforcement frame we are going to installed to prevent movement of the car and frame.

The plates in place for trial fitting. Under the plates we taped 2 layers of masking tape to protect the paintwork.