The floor is welded.

The best wishes for 2016 to everybody.

Today I started with the mustang where i stopped last year.
Welding the floor.
All That was left were the 4 corners that needed some finishing.
The front was easy a few cuts and a few welds and that was that.
At the rear I had to weld in some parts that were cut out in order to remove the floor.

The passenger side was the easiest the part was in good condition. I ground the edges and tacked it in place.

 Then the welds are done and the part is now firmly in place.

 For the driver side I had to make a new bottom for the part. It was rusted away. The bad rusted section was cut off and a new section was made.

 They were then welded together.

 Next the weld was grounded flat and the part was welded in place.

That was it for today.

The floor is now in place and fully welded.