Steering column

Today I started with the fabrication of a small square screw that was missing for the pedal bracket.

 I cut it from a piece of plate 6 mm thick then drilled and tapped it with 5/16" UNF and the put it where it needs to go.( see picture below).

 Then I installed the windshield wiper assembly to the car.

 Some fiddling was needed to get the blots in. But finally it is in.

 Then I started with the steering Column. I wrapped it with some soft paper so I don't scratch the surface. Then every thing was bolt to the car.

 And then I attached the steering joint to the column. The bolts need to be tightened and then we can proceed with the rest. But for now the steering column is attached to the steering house.