Installing seals

The pieces i glued in yesterday I did not touch yet.
I immediately started with the front suspension. Taking it apart to put new seals on the ball joints. They were damaged previously while taking the car apart.

 After taking it apart and putting the new seal in place I did reassemble it again Tightening the bolts down to spec and installing new cotter pins. so this front suspension is ready to roll again.

 I had some time left so I decided to install the front splash guards. These will keep moisture and grime front reaching the rear of the lights.

 I also applied some paint on the pieces I glued in yesterday.

 And then the splash guard on the other side was mounted.