Preparing for paint

This morning I started with removing the paper from the car and preparing it for the move.

 Above a look from the front, below a look from the rear.

 Then it was time to get the truck and trailer  and load the car on the trailer. In driving the car on the trailer I noticed that the clutch needs some adjusting.

 Then it was time for the drive to the paint booth.

 The car was driven to its place and then the preparation began. Sanding the whole car ones more. Then a throughly cleaning with air to remove all the dust and then we were able to tape the car off again.

 All that preparing was done by me and 2 coworkers.

 At the back side near the taillight where we made the repair the paint was working up. So we painted it with some clear to seal it off.

  This part will need some more sanding tomorrow with a scotch pad before we can start painting.